...switch within 1/8" of the magnet. Also, check to see that the wire is not damaged, and is connected to the console. 2nd Step: tight the keypanel vs Display board and clean with contact cleaner ...
Question about Treadmill Doctor Exercise & Fitness
...switch, see the diagram, clean it, and tight the wires connectors very well.2) replace the batteries.3) clean the contacts batteries with special cleaner4) retight the spring contacts batteries for ...
Question about HEALTHRIDER Exercise & Fitness
...switch, see the diagram by 1/8" or 3mms.3) Tight the flexible cord from keypanel vs Display board + then tight the connector from Display board vs Lower Board( Main Motor Controller Board)4) Adjust ...
...the reed switch, clean , and tight the wires connector very welll, see the diagrams2) Tight the ribbon cables, from keypads. tight the display board vs lower board.3= Try again and proof.God bless ...
...vs lower board. 5) attached the sensor reed switch by 1/8" or 3 mms adjusted according. 6) Test the main motor controller board for 115 Vca, and then +5 vdc for output coming to display board very ...
...vs display board .4) Tight the connector from display board vs main controller board.5) Adjust the Reed switch +speed sensor(touch the magnet with another face in the motor).See the block
Question about Proform Exercise & Fitness
...switch first.2) change the batteries if have it.3)tight the flexible cable vs display board.4) tight the connector from display board vs lower board.If the problem persist.you must test the ...
Question about Exercise & Fitness
...switch, test it, clean it, and tight the plug or connector very well.see the diagram 2) Ribbon cable tight for keypad, and tight the upper plug vs lower plug 3)replace the new batteries, same mark, ...
Question about HEALTHRIDER Exercise & Fitness
...vs lower board(Main motor board)4)Adjust the reed sensor switch by 1/8" or 3mmsSee the diagram attached.5)Measure input voltage for 115 Vac to input of main motor board6) Measure input for power ...
...switch, see the diagram attached, clean, and tigh the wires connector very well.2) Tight the ribbon cables from keypads+ tight the wires connector from display board vs lower board. see the block ...
33 questions posted
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions