Life Fitness T3 Treadmill with Advanced Console "speed error 2" Questions

...error 2" 1)VSD(variable speed drive) MICROPROCESSOR eprom/sram failure: Exchange VSD board.2) Belt speed pickup,failure in the speed pickug, to due motor, wiring or controller ...

...error. 1) Adjust the speed sensor   2) Tight very well the connection from speed sensor. 3) Faulty Sensor speed  4) Faulty Main Motor measure for 115 VAC without load. 5) Main motor ...

...error 2, please advise what it is this is a probably a faulty sensor speed see the diagram attached. However depend of your mark , model, can be e1 ,tight the connector very well, and clean it. Test ...

...speed sensor is inoperative. 6. The lower PCA is bad. 7. The lower PCA to upper PCA interconnect cable is bad. 8. The upper PCA is bad Error 45 :The lift control system has detected that the lift is ...

...Speed error (The treadmill running speed is 3.2 kph faster than the displayed speed). The treadmill will stop immediately when the console detects this error. E2 Speed error (The treadmill running ...

speed error message when I start the belt It was working fine then I turn it on it starts and gets a speed error message Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Precor Error LS,

Error 2 means P0 P1 P2 P4 P5 ( P0 ....Min. ,Speed P1 ....Max, Speed P2 ....Mid.Speed, P4 ....Min.Slope, P5 ....Max.Slope )have a wrong parameter values. You have to go the engineering mode and set the

...error appears. If able to access the speed sensor wiring, measure the DC voltage between the speed sensor leads. Two of the leads will always read about 5 VDC. Two will toggle between 0 and 5 VDC as ...

error. This is caused because the belt was commanded to move and the opto (speed sensor on the motor) has not seen any movement or the belts movement was interrupted prior to it reaching its commanded

...error This is probably a faulty speed sensor or the speed sensor is not plugged in properly. Its also possibly a faulty motor control board or lower board. The error codes will differ between makes ...