Coleman Powermate Proforce 2500 Generator "oil fouled plugs" Questions

...throtle, it dies. Sounds like a fuel problem? Any suggestions? Change your spark plug If the fuel oil mixture is too oily it will foul the spark plug and no cleaning will get it right. If there is

...oil fouled. The breather is not plugged; the engine has a fair amount of blow-by. The oil is not over filled; could this be a bad head gasket? Thanks! Even though the engine is 13 years old but has ...

...oil indicates sticking or broken piston rings. If it has sat for a long period, best thing to do is spray some sea foam into the cylinder, run it under heavy load for 30 min and hope it seats. If it ...

or replace. Give it another go. PS: I sometimes use a propane torch to clean the oil from the end of fouled plug if a new plug isn't available. May get you through for a bit. Careful not to get to hot

Have a 2005 homelite generator that I can not start. Have oil that was in before. Added gas. Flipped switch and hit the choke. Pulled chord and nothing. Check the following: 1. The fuel - if old fuel ...

...oil. And I"m at 5600 feet. And outside temp. Is about 38 degrees. What have you tried so far? An engine needs fuel, air and spark to work properly. Fuel - Has the generator been sitting for more ...

...oil you may also need to clean the carb. Also check the spark plugs for fouling. Once you're convinced that the engine has no service related issues, check the governed throttle setting. To do this ...

fouled---if so clean-if not ---connect the plug lead back up and lay plug against the engine---- then turning it over to observe if there's spark--- if not check to see if it's equipped with a low oil

fouled plug? Full of Gas and Oil. Air filter is new. If plug is fouled, that would explain running rought and some smoking. But for something to happen all of a sudden, I would suspect bad fuel, which

...changed. are your plugs fouling with oil? then you may have a valve or ring problem, if you are burning the plugs up your fuel is too lean. also, make sure your timing and all with distributer are ...