what grease do you use for a makita demolition hammer alternative grease MAKITA HAMMER DRILL GREASE 30G (181490-7) or for the older HM models Hammer grease Makita P-08361
the gears and pistons.also take bit holder off and see if unit is full of dirt in the lower end,if its full of dirt.clean oout the dirt and add little heavy grease around the out side of bottom hammer
Question about Makita Hammering
...be used in makita hm1304 demolition hammer? You require Hammer Grease, All good tool shops should have grease to suit. see link below:- Hammer Grease 90582 for Makita Power Tool eReplacement ...
...hammer. It came without grease. How much grease is required to initially fill the case? Is there a different type of grease that can be used? If this was a new unit, it comes with the proper amount ...
What kind of oil grease goes in a. Hm1301 makita jack hammer A-90582 2 tubes of grease 30cc http://www.acetoolonline.com/Makita-Tools-A-90582-Hammer-Grease-30Cc-p/mak-a-90582.htm
...For outside chisels Inside its depend on the model but most time its a Makita 181490-7 or for the older types Hammer grease Makita ...
...hammer uses grease available in repair kit. Check ebay or parts house. Remove four hex bolts on the mid section of the hammer and pull off the lower end. Most of the grease goes here. There is a side ...
...The bit should have grease on the end going into the hammer to make it work in the tool better and make it easier to take out when you are done. You have to put the grease on the bit
...grease. If your hammer is used constantly / heavy / hot climate, you can increase the life of the tool by greasing more often. Most damage is done by using long cord or generator with too high or too ...
Question about Hammering
Electric kango dem. hammer needs lubricant is it oil or grease Mod. 800 What sort of grease dose go intoit A basic lithium grease should be ok. Get it from the car shop. nothing too heavy.
5 questions posted
Usually answered in minutes!
7 Questions
2 Questions
5 Questions
5 Questions