Craftsman 10" Table Saw "repair" Questions

Ad

I need to fin d a motor repair shop in Dallas or East Texas that specializes in small motors DEWALT OR DALLAS ELECTRIC MOTOR Try a simple internet search for a small electric motor repair company. ...

Ad

...at the commutator and is shot,it is cheaper to buy a replacement motor than have the armature repaired I think that when it comes to heavy equipment it is important to make sure that it runs ...

Ad

...burnt out Can I get my motor replaced, if so where/who do I contact? Contact Bosch for authorized repair centers near you. if you are handy with tools, you maybe able to replace the motor youself. ...

...would be to take it to a Bisch approved service center, or call them and get an estimate cost on repair. If too high it may not be worth repairing it over the cost of a new saw. If it is still ...

Question about Jet Saws

1 Answer

...recommend replacing the switch. BEFORE removing anything make a note of all wiring. Most local repair shops should be able to match the switch up for you. UNPLUG TOOL before attempting any ...

Question about Makita Saws

1 Answer

...work into the blade too fast. if you can, remove the motor and have it checked by an electric motor repair shop; don't be surprised if the cost of repair is close to the cost of a new saw. in the ...

...or sometimes run backwards. I sounds like yours has this problem. Unfortunatly the only way to repair the motor is to replace the field coil. This is a fairly involved repair and you might ...

...it but because Sears builds some of their tablesaw housings out of plastic, it cracked beyond repair when it was used on a job. I trashed the tablesaw and kept the motor. It barely got used!

fence is out of alignment and I am not sure how to repair it? There is a couple of screws holding the fence perpindicular to the front guide. loosen slightly, square up fence and retighten screws. My ...

Question about Rescue Saws

1 Answer

...it https://d131fdiz3j4gax.cloudfront.net/product-images/normal/jones-stephens-corp-stainless-steel-repair-clamp-r60-050 You are better off using a repair clamp. Measure the outside diameter of the ...

Not finding what you are looking for?
Craftsman 10" Table Saw Logo

473 questions posted

Ask a Question

Usually answered in minutes!

Top Craftsman Saws Experts

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

john h

Level 3 Expert

29494 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Craftsman Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...