...tube tester is used to test tubes. Years ago, you could walk into an electronics store like radio shack and test your tubes. I suggest you take the amp to good music shop that repairs amps. They will ...
...at which tube is bad will be expensive. With the renewed use of tubes in amps, there may be some tube testing available at a music store. Call around and see. Pull all you tubes and go test
Changing preamp tubes in marshall dsl50 50 where doe the bias tube go what slot The bias voltage goes to the output tubes only. These go into the larger tube sockets.
low voltage to second power tube hot rod deville Tube has heater voltage but runs very cool with loss of power and unwanted distortion change out pre amp tubes I suspect a burnt out screen resistor. ...
...into your mouth and make music. Remember that the tube in your mouth and your mouth have to be close enough to an active microphone to pick up the sound from the talk box. Now what was the
do 4-10 devilles need to have the bias adjusted when replacing tubes? When replacing the two output tubes you should check the voltage at TP26 or either cathode pin of the power output tubes to ground
...nobody's complaining about his tone! A lot more pros than people think get their tone from a pedal board with a foundation over drive, a fuzz box, etc... Best Overdrive Pedal For Tube Amp Music ...
ibanez tube king pedal wont work unit powers on but no output, no glowing tube. has new Groove tubes 12ax7 tube Check your power supply output voltage. It may be putting out (under) the correct ...
v/u meter not operating. no tube light? If the tube is not lit, then it may have a broken heater... replace the tube... OR the power supply may have a problem.
I can't use my classic 30 any more because one of the tube sockets makes an awful loud noise. I have switched tubes, so I know it's not the tube. the tube socket is going bad replace tube socket.
166 questions posted
Usually answered in minutes!
25 Questions
18 Questions
12 Questions