...home theater system keeps blowing fuses. I recently had a power surge and noticed that the fuse was blown. I replaced it with the same kind and now eveytime I connect the power cord to an outlet it ...
home. The power went on briefly then shut off several times, now the television will not turn on. We had the tv plugged into a surge protector too. Check the main fuse in the power supply, the TV also
...AC fuse, when the MOVs conduct, it will cause the main fuse to blow to stop any surge from coming through the second time. If you are going to DIY and have proper tools, electronics knowledge, and ...
AC to DC converter, etc. You will have to do component level repair at this point, better off getting new power supply module. I did not anything on the web yet using your model number (correct number
...AC fuse to blow. You have to look at the circuit board where the power cord is attched to and that where the fuse should be close by. Basic LCD monitor and LCD TV troubleshooting guide: ...
...AC fuse first in the power supply module, since most TV will have surge protection devices, MOVs (Metal Oxide Varistor) same as use in your surge protector outlet strip, they are installed after the ...
...home. The supply itself will also cycle if it has an internal problem; once again, to prevent destroying itself or anything dependent on its outputs. Supplies built a couple decades ago could only do ...
...AC Voltage and Current, and Heat and Over Voltage. All of which, I have no doubt it was exposed to before it went "Pop" This is only a symptom of a far greater problem, to come, no doubt, soon, the ...
Home Depot) ____________________________________________ Okay first: Unscrew all the screws around the perimeter the back panel. Second: Unscrew the main center screw on the back panel. Third: Unscrew
46 questions posted
Usually answered in minutes!
405 Questions
364 Questions
299 Questions
263 Questions
243 Questions