...hot goes in fine,then the pump released the water fine. I changed the belt. Could this sound to you like the electrical motor has gone? Many thanks for your patience. Many Regards. W. Lima Open ...
Question about Kenmore Washing Machines
...tub. Went throught the diagnostics and machine worked fine. Put a small load in and failed at the end of the cycle...did not properly drain nor would it spin, however, it did agitate. The pump seems ...
Question about Washing Machines
...tub - or no hot water - or no cold water Check that the water supply valves are turned on Inspect the water supply hoses for kinks Check the filter screens Test the water level switch Test the water ...
...hot and shuts down or because of a problem in the control mechanism which manages the the starting and run time of the pump. First, I would unplug the washer from the wall outlet and probe under the ...
...hot. if it stops and starts it coule be a power board problem If your washer won't drain, check these: It spins, but doesn't pump It doesn't spin or pump It pumps, but the water returns It spins, but ...
...hot water to install a new Radiant Boiler. I set it for cold water but at the end of the wash cycle it stops and starts blinking F20 "F20" is a No Water Detect error. It is an indication that you ...
Question about Electrolux Washing Machines
...hot water should enter through the detergent compartment. 3. Turn the program knob (2) clicks from the start position. The bleach water solenoid will activate and cold water should enter through the ...
Question about Kenmore Washing Machines
...hot and shuts down or because of a problem in the control mechanism which manages the the starting and run time of the pump. First, I would unplug the washer from the wall outlet and probe under the ...
...tub also has alot of water in it when it stops. I HAVE TO PRESS CANCEL AND SET THE WASHER TO SPIN ONLY for the wash to finish. turn program knob to spin and hit start then hit cancel within 5 seconds ...
Question about Frigidaire Washing Machines
...hot water should enter through the detergent compartment. 3. Turn the program knob (2) clicks from the start position. The bleach water solenoid will activate and cold water should enter through the ...
401 questions posted
Usually answered in minutes!
992 Questions
874 Questions
371 Questions
398 Questions
255 Questions
