Question about Lexmark Office Equipment & Supplies
rollers under the platen. 1 - remove the platen by squeezing the black plastic clips at the ends of the platen and pulling the platen straight up. 2 - pull the paper pan out, 3 - push down on the feed
...daisy brogham The paper is not feeding mechanically or automatically. It goes under the roller/platen only when I release the paper release leaver. The platen moves only about 180 degrees and ...
Locked 35l Thank you, I had the same problem and now I don't. To the right, below the platen roller knob, there is a silver lever. It can only be depressed (locked) when the platen is in the central ...
rollers under the platen and the platen as labels have gotten stuck on them. Some typewriters you can remove the platen to get to these rollers but we can't seem to be able to do that with the ML 100.
Question about Smith Corona Office Equipment & Supplies
...platen and rollers. (But try really hard NOT to get WD40 on the rollers or the platen. The rollers can be hard to get to). DO NOT do this if this is an electric. They have a rolling platen under the ...
Question about Brother Office Equipment & Supplies
...platen roller there are several smaller rollers . 6 to 8. inspect this area for foreign debris. clean with 70% alcohol. reseat the platen roller and test.Platen will lock in if not its in that ...
Question about IBM Office Equipment & Supplies
...rollers. Cannot get the new roller in place - there must be some trick? Buy another feed roll. At each end of the platen (black roll) there is a lever to press down and the platen will pull out, then ...
Question about Brother Office Equipment & Supplies
...platen roller, and the roller will lift right out. If the label left any of the rollers sticky they must be completely cleaned before reassembly, Goo-Gone is a good product to remove gummy labels. ...
Platen roller is slipping Hi. The platen roller is not turning when I turn the knob. The knob just slips. Does anyone know if this is just a question of tightening a screw or something more serious ...
Question about Lexmark Office Equipment & Supplies
...is only printing part of the character. is there an adjustment I can make? I have no manual. The platen (roller) is not fully seated in the side frames check to be sure the latches are lined up ...
441 questions posted
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions