Question about Nexus NX Televison & Video
push the power button or the remote, the power light just stays red. It used to turn blue, flash power on the screen, then power off back to red. It doesn't even do that anymore. While it was starting
...push power botton when i push the power button on my tv it will not turn on.i keep pushing the power light comes on but goes right out.i wait awhile and then my tv will come on when i push the power ...
...are on the right choice "off". also make sure picture setting is on "standard" not cinema, expert or any other setting These buttons are sometimes near the power button and easily pushed by
Question about Scott Televison & Video
...push the power button These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. ...
...program anything. Below the power button are 6 buttons labeled TV, DVD, etc. As soon as you push the DVD button the remote should work it. Remember to push the TV button again to make it work the
...power button is pushed either on the remote or on the TV, nothing will come on. Sometimes the green power light flashes a little faster than 1 time per second and other times the power light doesn't ...
...power button. The remote doesn't even work. I have the original remote which I have been using and also I programmed my cable remote to the tv and both have been working fine. 1 day they just stopped ...
...release. Push & release the power button & the red light will remain lit. Push the CHANNEL UP button over & over slowly until the device turns off. When device turns off press OK ...
...push the power button about 120 times the led in the front turns from red to green when powered on when the power button is pushed it turnes green and goes back red. what is going bad? In about 90% ...
...push the power button and it makes a click like it is turning on but the screen won't turn on. What should I do? . The tv is in stand-by mode and the red power led is on. You must push a channel ...
14 questions posted
Usually answered in minutes!