Question about Kenmore Elite Washing Machines
door has not been opened for 3 consecutive cycles or the door switch is open while the door is locked for more than 5 seconds. Possible Causes/Procedure -Door not opened during 3 consecutive cycles. 1
Question about Kenmore Elite Washing Machines
door has not been opened for 3 consecutive cycles or the door switch is open while the door is locked for more than 5 seconds. Possible Causes/Procedure -Door not opened during 3 consecutive cycles. 1
Question about Kenmore Elite Washing Machines
...door not locked but the door is locked and will not unlock. it will not start either. Try pressing 'end of cycle' for 3 seconds. You hear a click? Then wait for 2 minutes before trying the door, do ...
...door position sensor that could be loose or malfunctioning? door switch not close properly when cloth hit door . door switch open .tight door hinges or sticky pad tape on door wher door switch ...
Question about Kenmore Elite Washing Machines
the door hinge bent down just some, causing the door not to strike that button dead on. If thats fine, then its likely to be the door latch assembly or the CCU board bad. The code is a door lock error
...WILL NOT LOCK MAKES A CLICKING SOUND Before removing try some WD40 spray on the door mechanism, not on door. first see door latch ,, if not locking replace ,,, part runs about 70.00 if im not ...
Question about Kenmore Elite Washing Machines
door has not been opened for 3 consecutive cycles or the door switch is open while the door is locked for more than 5 seconds. Possible Causes/Procedure -Door not opened during 3 consecutive cycles. 1
...door will not open. I had 2 small rugs being washed and I notice the water did not drain. So I pressed Drain/Rinse. Since then the door does not open. I can't really see in the washer itself, but ...
...the other makes will allow the washer door swing to be switched. no all washing maschines are made with a left hand hinge and are not reversable, you can reverse the dryer door if needed not the ...
...not attached to Door 2) inspect the door lock/switch mechanism 3)check the wireing harness connectorsfrom door lock/switch assembly and the ccu or central control unit 4) the door lock assembly has ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions