Question about 3Com Baseline Computers & Internet
...port. Be sure the terminal emulator program is set to VT-100 management using compatible, 38400 baud rate, no parity, 8 data bits and Console connection one stop bit. Use the included cable, or be ...
...through hyperterminal. I've set all the settings like it says to in the manual but I just get a blank screen. I'm not sure if this switch's serial port baud rate can be changed. Try various
port using a console cable. Make sure your settings for hyper terminal are on COM1 and the baud rate is 9600. If you are trying to telnet, you will need to assign an IP address to the VLAN in order to
Question about Allied Telesyn Computers & Internet
...port to connect to the device. b) Set the data rate to 115,200 baud. c) Set the data format to 8 data bits, 1 stop bit, and no parity. d) Set flow control to none. e) Under Properties, select VT100 ...
port LEDs on and doesnt start at all (connecting with HyperTerminal - nothing on the screen) and the second one starts well, shows all the logs on the screen, but when I;m trying to type anything - it
Question about 3Com Baseline Computers & Internet
...port of the switch. Use the following terminal settings: 9600 baud rate No parity 8 data bits No stop bit Unplug the power cable. Hold down the mode button while reconnecting the power cord to the ...
Question about Allied Telesyn Computers & Internet
...port to connect to the device. b) Set the data rate to 115,200 baud. c) Set the data format to 8 data bits, 1 stop bit, and no parity. d) Set flow control to none. e) Under Properties, select VT100 ...
connector at the back labeled "console port" you need to connect this to your serial interface on your pc or laptop. With 3Com you also need to set your baud rate to 19200 as this the default for 3Com
10 questions posted
Usually answered in minutes!
2 Questions
12 Questions
12 Questions