Stihl 16" Chainsaw Bar Chain Saw 018 025 Ms 180 250 "adjusting carburettor" Questions

...adjusting the carburettor screw. I have the same saw and also wanted to adjust the oil flow. I didn't change the carburettor and it's still cutting away without doing any damage. It's meant to use ...

...carburettor settings for a McCulloch Mac 120 Chainsaw. Hi williamsc32...Before you remove or try to adjust your low and high speed jets you should always count the number of turns it takes to lightly ...

...adjusting the carburettor fuel screws after referring to the instruction book (and ensuring the air filter is clean). If this doesn't cure the problem it would seem the fuel system, including the ...

I NEED TO KNOW WHAT THE HI AND LO SCREWS ARE FOR ON A LOMBARD GAS CHAINSAW ITS FOR THE CARBURETTOR? The Hi screw is for High speed adjustment and Lo screw is for low speed or idle adjustment.

adjustments carb zama Carburettor settings for the H and L screws and the LA screw Hello, Check this site: http://tekindoor.com/miscellaneous/stihl-chainsaw-carburetor-adjustment/ Theher is good ...

Starts, idles and runs but quits after a few seconds of cutting The chainsaw is about 15 years old with good compression. The problem started when it runs at high speed all the time. I bought a ...

How do I adjust the carburettor on my Makita DPC 6200 why did they some how move on there own? sorry I'm not rude, but unless they have been tampered with there is no need to adjust them. If all else ...

ms 180 stihl will not run wide open Most likely cause is a dirty or out of tune carburettor. If there is a high speed adjustment, try turning that our a bit.

user-guide-instructions-owner-manual/ECHO/CS-400-_E The idle speed of the negine may be too high. Page 26 of the manual gives instructions for adjusting the speed with the "T" screw on the carburettor

stihl o1oav manual chainsaw adjustments for carburettor on stihl 010 chainsaw Hi, one and a quarter on the low and one on the high, regards Phil.