Question about Reebok Exercise & Fitness
...and speed responds but there is a Maybe the silicon oil is making your belt too slick to get a grip. If you can access the rollers you may be able to remove the excess lube with a cleaning
...belt in side the hood may be too tight. or the tsc may be set too low so take a small flat head after you remove hood and on the mother board should be an adjuster turn it while tread mill is safley ...
Question about Horizon Fitness Exercise & Fitness
...remove silicone lubricant from the running belt of my treadmill You need to be careful if you are trying to clean the belt soa s not to damage it. Use something like methylated sprit - or some other ...
...belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you ...
...Three reasons my cause the belt slip: 1. The roller is small. 2. Uneven silione oil. 3. Belt is loose. Just check them. We are the professional belting manufacturer,any more question,can contact
...oil in the treadmill ? Unplug unit remove motor shroud then plug unit in then start it observe where the noise is coming from. The best way to check the rollers to see if the bearings have failed is ...
Question about Exercise & Fitness
remove the safety key 2. Press and hold incline down and speed down, at the same time insert the safety key 3. You can release the ?Down? buttons. (you will now hear a beep) 4. Press Speed up 6. Press
Question about Cardiozone Exercise & Fitness
...oil and check sensor position -- where is the sensor. thank you Unplug your unit, then remove motor shroud have a good light the sensor is either mounted on the frame by the front roller/pulley unit ...
...remove the towel. Open your lube packet and use half of the package to make a half circle on the deck, from the front outer portion of the deck toward the center and then back to the outer edge. Use ...
...oil where it needs to go. As far as the walk belt, just make sure that is stays in the center of the walk board. Now your front roller and drive belt. The roller does not get serviced, it has ...
3 questions posted
Usually answered in minutes!
188 Questions
112 Questions
99 Questions
96 Questions
64 Questions