Kyocera FS2020D ECOSYS Monochrome Laser 35ppm USB20 Parallel Interfaces 500 Sheet p Printer "printer top cover wont" Questions

...printer top cover is open, or there may be something wrong with the print cartridge. Solution Close the printer top cover. If the PRINT CARTRIDGE light continues to blink, continue with the following ...

...top covers notch is brocken you can insert a piece of folded paper on to the printers cover censor, look at the cover and see if you can find a pointed plastic, that is the pointer look where it ...

...top cover of your printer. tilt the printer with the front going upward. u will see two screws on the middle of front portion of the printer. remove it along with the screw on the side of it. then ...

...wont come out right side seems stuck the arm from the top cover moves a devise in and out to hold toner in place. Try disconnecting from top cover and move it up and down to see if toner is

...top cover of the printer and remove the print cartridges. Close the top cover of the printer. Press the power button on the printer to turn the printer off. Disconnect the communications, (USB or ...

...printer 6840 wont print .keeps on saying top cover is open when it is actually closed. I could not print as it keeps on saying the top cover is open when it is already closed. I changed the ink ...

...top cover of the printer. 2. Remove the print cartridges. 3. Clean the copper-colored contact points on the cartridges with a damp, lint-free cloth. Use a dry, lint-free cloth to remove moisture from ...

printer/take the top off so i can reach inside, i have taken out four front screws and tried to lift up support hing at the front right out but it wont move? help pleasseeee you have to squeeze in the

...top cover, reinsert the power supply, and power the AIO on. Did the error message return? Yes: There is a hardware problem with the printer. Continue to Contacting Lexmark. No: Continue to Step 4. 4 ...

...printer, on the top right inside of the cover, there is a small white pin fastened with one screw. Losen that screw a bit, pull the pin out as far as possible (to make it as long as possible) and ...