2010 Ford Ranger "location car amp fuse" Questions

...location map (just in case it was replaced with an incorrect amp rating). There are two fuse panels in most cars. One is inside the vehicle usually located under the dash. These fuses are typically ...

...amp cb fuse a 20 amp cb fuse is large fuse usually located in a plastic case in the engine compartment. This fuse is over 1 inch long and I believe the 20 amp is green in color and should say 20 on ...

...Location Electric Fuel Pump 20 Amp Fuse Power Distribution Box Headlamp Switch Feed 40 Amp High Current Fuse Power Distribution Box #36 Circuit Alternator Output #2 15 Amp Fuse Power Distribution Box ...

location for fuze for lighter for a 1996 ford ranger The fuse for the cigarette lighter can be found in the power distribution box under the hood, not in the fuse box within the cab. It can be located

...location is in the fuse/relay box under the hood. It's a 20 amp fuse in position 23. If the fuse is OK there's a fuel pump shut off switch located under the the glove box just above the carpet. To ...

...headlamp fuse. The interior fuse box #4 and #8 (10amp minis) control the left and right low beams. Fuse #33 (15 amp mini) controls the high beams. If you need anything else,drop me a line. ...

...location # 9 ( P.S. - don't forget your fuel pump inertia switch , in the right front passenger area , by the right front kick panel )Sometimes this gets kicked by passenger or if the car is bummed ...

...amp; CD eject button works. fuse#6 10amp is good with p this all happen after dead battery change out. Battery was 5yrs old temps dropped into the teens. You should have a couple of fusable links ...

...location of shift lock fuse the fuses are in the under the dash fuse box fuses f2-9 and f2-10both are 7.5 amp fuses ,I would also check your brake light and make sure they work if not you mite have a ...

location the wiper fuse is always located in the fuse panel inside the car, never under the hood, if there is not a fuse diagram on the fuse box cover you will need to just visually inspect them 1 by1