Loewe Aconda ACO9303 30" TV "reset button lighting transformers" Questions

off. However there is a failure in the red standby and green power on mode which both lights up and resets the TV to standby mode. Common problem with this model is the line output transformer

Bad RCA 32 Tube TV My RCA f32650 just turned off on will not turn back on.. I checked for reset buttons-none and plugged it into the wall (instead of the power surge protector) and it still won’t turn

...reset button to. Something in high voltage section is shorted. check the horizontal out put transistor. take it out,ohm it out to see if it is shorted. Sometimes when the horziontal out put goes so ...

...button / remote wont start- could it be fuse ? checked all connections if their is no any power indicator that light in the front panel, it was a power supply board failure. you must look first the ...

...reset button and unplugging and plugging it in somewhere else, but to no avail. Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output ...

...reset itself, I've tried holding down the on button, and opening up the menu, but nothing has worked so far and it just will not turn on at all. And I have no remote control for it. Someone please ...

...contact manufacturer for parts or have a service proffesional repair it. First thing to do is reset ( see link below) and see if it resets otherwise if problem continues it will need some work ...

reset button will not reset the tv. About the second user with the remote problem, the problem is likely a bad IR sensor/board inside the TV, The IR circuit is the one that receives the remote signal.

button the TV will not turn on, but the LED will flash 5 times rest flash 5 times rest continually until you unplug the power cord from the wall. I tried to reset he the TV with the remote contol, but

reset button? Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor