Question about Heating & Cooling
I have a White-Rodgers 50E47-843 controller. What voltage should the HS1 terminal show during the warming cycle of the Hot Surface Ignitor? The L1 terminal shows 120VAC, the Gas valve purges for a ...
electric blanket does not warm have a sunbeam electric blanket when plugged in one controller flashes. the other controller works fine and one side of the blanket warms. any ideas? Sorry to have to ...
Question about Heating & Cooling
...control at the advice of an HVAC repairman - no help. Filters are clean. Blower and inducer fan run properly. I have run out of ideas. I did not see that your indoor fan motor started. Near your ...
...control panel comes on and it does nothing when the power button is pressed. Underneath the heater element are two thermostats that are run in series with each other. Inside the wire that connects ...
Question about Heating & Cooling
...throw to the burner see the following steps:f the burner doesn't run, set the thermostat a few degrees higher than normal to see if it comes on. If it still doesn't come on, check switches, ...
Question about Goodman Heating & Cooling
...line with it. This is not a solution but only a suggestion before running out to purchase the main control board, as most places will not accept a board back if that is not the culprit. Good luck ...
53 questions posted
Usually answered in minutes!
13 Questions
7 Questions
6 Questions