Kenmore 12102 "sewing machine material pulling" Questions

machine wont sew Material immediatly gets stuck in stitchplate You may need to get a scrap piece of material to lead off with or hold on to your thread and gently pull it to start your material.

...feed have a riccar 706 sewing machine can't get material to pull through foot feed you need feed teeth Pulling at a height of 1mm and you need pressure from a presser foot on the top. Check ...

...sewing machines have what is called a buttonhole lever that is to the left of the needle that has to be pulled down before the machine will make a buttonhole,here is a link for a free manual if you ...

...the feed dogs and bobbin to check if material or thread is packed underneath? In attempting to dislodge the fabric, the timing may be out of adjustment. Suggest a sewing machine repair

...the feed dogs engaged? Janomes usually have a feed dog sliding switch, either on the back of the sewing machine at the bottom, or behind the accessory case. Be sure the check it out. Hope this

...sewing machine for thin material do the following. 1.Use a fine needle, 2.Use a fine thread,(upper & Lower) 3.Reduce the the thread tension, Upper& Lower) 4.Reduce the presser foot tension, 5.Reduce ...

...sewing machine 1030 feed dog will not pull material in The feed dog goes up and down and will reverse the material; it just won't pull it in to do forward stitch. What's wrong and can I repair it ...

Material is not being fed thru When I put the material down to sew thru. nothing is pulling the material thru. Check for lint in feed teeth

...sewing. Machine won't feed material. I have to pull while sewing. First of all stop pulling that will only bend your needle and cause further problems.  Check to make sure your feed dogs ...

machine has difficulty moving the fabric. Try stitching on different fabric and see if it makes a difference. Also, if the material you are stitching is somewhat sticky, it will stick to the bottom of