...on the back side, use a ball point pen to push it in, this will reset your router back to the factory ...
...of the router, press in for about 10 seconds with a ball point pen and release, this will set to factory default, but set it back up using a wired lan cable and not
4. Continue to hold the button in until ALL of the lights on the modem start to flash simultaneously. This will reset the modem back to factory defaults, and may recover your modem after you have made
...factory default setting....just follow these steps,ur issue will b resolved U dint specify that whether u r using the cable Internet or DSL!! Steps for Cable internet... 1,connect the blue cable ...
...you started. Additionally most routers have a reset that will change everything back to default factory settings. Doing that may change settings you have not written down. Those settings
Question about EnGenius Computers & Internet
...4. After clicking "Save/Reload Settings" simply click the "Reset" button to restore the settings to the factory defaults, then "Restart" to reboot your device and cause the changes to take effect. ...
...factory default. 1.Locate the reset hole on the router. Usually on the back or on the side. 2. Make sure that the router is on./ 3. Use a ball pen or paper clip or something pointed to press and hold ...
Question about D-Link Computers & Internet
...4 times and stays on with the signal light Try resetting the router.. There is a small hole located on the back of the router that you have to stick a ball-point pen into to reset. This will set it ...
...factory defaults. Some routers, like linksys, don't have an actual user name so be sure you're leaving that blank. If it is a linksys, the default username is blank, and the password is admin. You'll ...
23 questions posted
Usually answered in minutes!
134 Questions
63 Questions
23 Questions
8 Questions