Question about Sharp Aquos Televison & Video
TV won't power up. The white lite blinks 2 long and 5 short : I have replaced the power supply board and the main circuit board and it still does the same thing : plug it in and the white light in the
...TV ON AGAIN 2 5 BLINKING CODE These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section ...
Question about Sharp Aquos Televison & Video
...TV will not turn on. The power indicator light blinks in a pattern- 2 long followed by 5 short blinks. I tried unplugging and holding a variety of buttons when plugging back in. The TV is about 19 ...
TV's power mains from power outlet. 4. Insert the USB stick into USB port of your TV. 5. Connect TV mains to the outlet. 6. Wait until power LED on TV's panel starts and stops blinking red-blue (about
...TV blinking a green power light and the TV will come on for literally 5 seconds then shuts off. I have unplugged and replugged, held the power button for 10 seconds and the light turns orange then it ...
...TV held the power, channel down and volume up buttons then plug the TV back in. Now it comes on and has sound but no picture. The power light does not flash anymore. These blinks [flashes] are fault ...
Question about Sharp Aquos Televison & Video
...tv LED power light turn on solid first.Few mins,than LED,OPC flahes.Power LED,OPC flashes,push power button again,do this at leat 5 or 6 times somtimes the backlight will come back on and work.The ...
tv power button back on and it works fine for like 5 min then shuts off again with the green lights blinking. The tv main logic board known as a tv Tuner signal board it is the causes and the problems
Question about Sharp Aquos Televison & Video
...it back in. Nothing. Then I went to take 5 minute ****. When I finished, the Power & OPC lights were blinking, and out of sync. I pressed the power button at the top of my TV and got a picture.
...tv.Go to the power supply section it is separate board where the power cord is connected.Using a multitester,plug in the power cord and measure for the output supply.see if the 5vdc ,12vdc and 24vdc ...
331 questions posted
Usually answered in minutes!
878 Questions
339 Questions
295 Questions
202 Questions
163 Questions