Question about Yamaha Ness Signature Series Kingpin Motorcycles
...throttle cable Help please!! PW have the stop\start\run switch and will not rev in the start position, there may be a problem in this switch, wire, or the ignition box which controlls this. The small ...
...throttle control/switch housing together to gain access to the cable ends. Disconnect the cables from the throttle grip assembly 2. Make a cone of stiff paper and tape it to the end of the cable ...
...throttle control grip and the lower housing, (remove friction spring, throttle friction screw and spring from the lower housing only if necessary), (only if and as necessary mark the position of the ...
...throttle operation could cause lose of control of the vehicle causing severe injury or death to the rider. Good Luck Steve Nice try, but starting in 2008, all touring models are THROTTLE-BY-WIRE, and ...
Question about Yamaha Ness Signature Series Kingpin Motorcycles
...throttle control is working smoothly, freely, and will return to closed position when you let go of it. If it won't do this, it is unsafe. Work with it until you find the problem. Failure to do this ...
...throttle body. The choke cable will typically have a small lever or plunger at the carburetor end, which is connected to the choke mechanism inside the carburetor or throttle body. To connect the ...
...check the tension by twisting throttle, there should be no play at all. Adjust as necessary. Try manually pulling on the control arm to see if you can rev it, but just be careful OK ?.... Good
Question about Yamaha Ness Signature Series Kingpin Motorcycles
...to get the engine to speed up. If the throttle grip does not seem to control the engine, then either the throttle grip is not secure on the throttle sleeve or you have broken cables. Good Luck ...
throttle slide it all the way onto the bars, then back it off just a little bit so the end does not make contact with the end of your handlebars. This will keep it from binding up against the bars and
Question about Yamaha Ness Signature Series Kingpin Motorcycles
...not listed your model. Generally, remove two or three screws holding the right hand control module together. Remove old cable, install new cable in housing, and cable end in throttle tube.
17 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions