...the hoses connect to) If the filter screens are clear and water seems to coming from the hoses with good pressure...the washer control board would need to be replaced GENE My washer keeps flashing f ...
...from the back of washer where the hoses connect to) If the filter screens are clear and water seems to coming from the hoses with good pressure...the washer control board would need to be replaced ...
...Pressure Switch If the washer is overflowing the pressure switch might be defective. The pressure switch is attached to a small tube which is attached to the outer wash tub. As the water level rises ...
...level pressure switch is normally on the rear of the right side panel of the washer. Check the air pressure hose and wiring connections. If no problems are found, you may need to replace this
...pressure to the washer and trigger the error. Replace the hoses if needed. If you have a High Efficiency washer, make sure to use HE detergent. Excess suds could cause the incoming water flow to be ...
...level pressure switch 134762010 senses and controls the water level in the washer. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your
...washer to access the pressure switch and pressure hose. With the washer empty remove the hose from the pressure switch located on the right side of the washer and blow through it to clear any debris ...
...pressure for washer must be at a minimum of 30 psi). Straighten the water inlet hose if it is twisted or kinked. If any proves to be ineffective, contact a professional to move forward
...pressure drops below 20 PSI the washer can have the following problems; * Slow Fill- low water pressure reduces the speed at which water flows into the machine. o Verify the pressure at all other ...
42 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions
