Beko WM5140W "drum bearings" Questions

drum bearings. Drum bearing failure is common on many washing machines due to water getting into them if the drum bearing seal fails. (Hotpoint and Zanussi in particular in my experience) To check for

drum bearings. Drum bearing failure is common on many washing machines due to water getting into them if the drum bearing seal fails. (Hotpoint and Zanussi in particular in my experience) To check for

...bearings and the seal that sits around the drum shaft and protects the bearing. Check the brass collar on the drum support thats sits in the bearing is not worn or grooved.If it is the shaft and/or ...

...drum. When the bearings have gone bad, the noise is constant the entire time the drum is spinning. Take the belt off and run the motor alone if you hear a high pitched squealing noise to check for ...

...cycle. Drum bearing failure is common when the bearing seals start allowing water to enter. You can take the belt off and spin the drum by hand, and if the drum rumbles, replace the bearings. ...

...drum by hand? if so bearings are not seized. can you hear motor rotate when you select spin? if not, then likely cause is motor brushes. do these simple tests and get back to me if you want. and ...

Hi Gene, I have an Electrolux FEX831C30 stacked washer and dryer. the drum in the dryer has completely come loose and has dropped to the bottom of the dryer cabinet. there were two screws in the drum.

...off. Do not see anything obvious that is missing. all 4 shocks in place,springs at the top holding drum in place. Although right front shock looks a bit rusted, as if it's been getting dripped

drum bearings i need to remove the drum bearings the machine is making a lot noise have looked at the drum bearings and they look shoot what tool do i need as per soultion 2 this is a hard drawn out ...

...drum. (When the bearings have gone bad, the noise is constant the entire time the drum is spinning.) Step 3Look for obvious dents and creases in the drum or look for coins or small objects stuck ...