Question about Citroen Xsara
...Head Bolt Torque 60-70 Foot pounds (Final torque) Torque sequence --------------------- front | 13 5 2 10 | of |17 9 1 6 14| engine | 16 12 8 4 3 7 11 15 | --------------------- Final torque must be ...
Torque settings head bolts 1998 Renault Megane 1.6 RT angle torque settings of cylinder head bolts, alot of confusing information at the moment, the settings need to be bang on or the head is history.
head bolt toqure subaru EJ25 headbolt toqure settings any ideas Hope this helps, from autozone site. Curt Application: Cylinder head bolt torque sequence Note : Torque sequence: --------- front | 3 1 ...
...head bolt torque specs I have 1994 Oldsmobile Cutlass Supreme with 3.4 Liter engine. I am replacing the head Gaskets and need to know the proper torque specs for the cylinder head gaskets. My manuel ...
Question about Citroen Xsara
...head bolt torque a nd cam shaft torque settings need head bolt torque and cam shaft torque settings Torque setting Toyota Land-cruiser 80 Series 4.5 1995-98 Engine code: 1FZ-FE, 1HD. Stage 1: 20 Nm ...
...Torque To Yield" head bolts(TTY) (that means the bolts permanently stretch during the initial installation.) You MUST use NEW head bolts when replacing or reinstalling the cylinder head in order to ...
head bolt tourqe settings on a toyota cressida Cylinder head bolt removal sequence Removal sequence: Front 3 7 11 13 10 6 2 1 5 9 14 12 8 4 ***CAUTION*** The above sequence must be followed during ...
Head bolt torque: 90-100 ft lbs., to be reached in 3 equal tightening steps, below is the sequence: 9 3 1 6 8 Front of vehicle 7 5 2 4 10 Main bearing cap torque: 75-85 ft lbs. Rod bearing cap torque:
...head bolt torque settings thanks According to my haynes manual for G-S reg, 1989-1998 it goes as follows, Stage 1:- Tighten all bolts by hand until bolt heads just contact cyl. head. Stage 2:-Tighten ...
Question about Citroen Xsara
...head torque settings 16 valve If yours is an Xu series engine, you need to use a torque wrench and an angle dial wrench. Tightening is in 3 stages. Stage 1: Tighten up to 60Nm (44 lb/ft) then fully ...
17 questions posted
Usually answered in minutes!
168 Questions
96 Questions
37 Questions
51 Questions
37 Questions