...first thing I would do is ask your self when was last time fuel filter was changed and you gave it a good tune up and replaced the drive belt dodge dakota will not start replace coil and pick up ...
...fuel pump not pressurizing when key is in run position. Replaced the distributor completely, fuel pump relay and the ecm. Still has the same problem. Could it be the camshaft sensor? camshaft sensor ...
...fuel delivery system. pump doesnt prime or cut on at all ( itll jus quit when im driving) but mostly when i slow down to a complete stop my truck will stall out. when i cank it back up it works fine ...
Question about Ford Ranger
...fuel injectors and are reading 14.4-14.8 volts, new distributer cap and rotor, wires and plugs, coil(is getting spark to the plugs, already tested spark), ground wires and power wires, bypassed the ...
...rail and system ), If it does not crank over and start within 5 minutes ( NOT continuous cranking ) or so of trying then that's your problem. Replace the fuel filter and fire er' up.. Hope it
replace fuel pump drop fuel tank and replace fuel pump Removal & Installation Disconnect the negative battery cable and relieve the fuel system pressure. Siphon or pump as much fuel as possible ...
...complete with new plug wires, replaced the MAPP sensor, PCV valve, had the timing checked and replaced the water temp sensor. These changes have helped but it is still doing it. It acts like the gas ...
fuel pump for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must
replace the PFE SENSOR Or sometimes known as the BACKPRESSURE SENSOR If you need parts only BUY ORIGINAL EQUIPMENT FORD PARTS BECAUSE FORD HAS SO MANY UPDATES THAT ONLY FORD HAS THE MOST CURRENT PARTS
10 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions