...engine keep on running even after the speed lever is placed at the STOP position, either turn the fuel **** to the CLOSE position or loosen the nut of high pressure fuel pipe on the pump side to stop ...
Question about Kohler Electrical Supplies
stops and the engine runs good. I think it is a bad valve guide or a valve isn't seated right and oil is running White smoke pours out of exhaust on my SV730 Kohler engine when I start it. Then it
Question about Honda Electrical Supplies
...Engine Honda 420 clone stopped as if the switch was turned off after running fine, tried disconnecting oil switch, didn't help, I can smell gas at the carb. Tried starting at a later date, ran for ...
...engine stops running after about 1 hour of run time check low oil shut off sensor... look for a yellow wire coming out of the block... if you disconnect it and it works... make sure you always check ...
...engine is only one piston, when it is running and I stopped it, after I stop it I can't stat it immedaitly it doesn't run mean it doesn't have the compression I can drive it without compressing the ...
Question about Diesel Electrical Supplies
...run another 4-5 hours. What is doing this. it could be a flow sensor in the fuel line to stop the engine before air gets sucked in form low fuel or broken lines I would first go to the tank vent
Question about Yamaha Electrical Supplies
...stops Engine will start fine with the choke on, then turn the choke off and the engine runs for a couple of seconds and stops agin, will not run unless the choke is on, any siggestions. clean tank ...
Question about Coleman Electrical Supplies
...only 2 volts show on meter instead of 120 volts. Wont run a flashlight. Model PC0525302.02 Just stopped sending power to outlets even with engine running. All outlets dead check the voltage ...
...7 days without stopping? Joe,If you ran your generator for 7 days, it would be running for 168 hours. You MUST stop the engine every 50 hours and replace the oil. Otherwise, you will trash the
...stops the engine. If so the switch is not grounded or faulty. If not... That circuit is damaged inside the housing. Those switches operate by grounding the signal to the coil to stop the spark. On ...
2 questions posted
Usually answered in minutes!
1 Questions