...paper is being grabbed. I tried the microfiber towel to no avail. I believe that the spring on the level bar is worn or needs tightening BUT I can get in to the printer. Any ideas on how to open the ...
...level of paper made a difference. nothing has helped. any ideas? thanks. Sometimes there is a spring in the paper tray which pushes the paper upwards so it presses against the rubber roller in the ...
Question about Canon Office Equipment & Supplies
...paper is full,ink level reads green?? I just made a copy yesterday and it was fine.I took out the cartridge to see--nothing?? help canon pc table top copier There are about 4 possibilites. The paper ...
...paper to the scan window but then catches and jambs as it enters the return slot. If we add a little pressure to the top of the copier lid it often will work. The lid does not seem to sit level - it ...
...aggressive cleaner (metho or similar). Another possibility is an uneven tension in the springs in the paper drawer. Check that the drawer when returned to correct position is holding the paper
paper gets jam in between check at the tray side when you open there is a level that is fixed in side with a soft spring between the sensor see if it can go up and down easly
Question about HP Office Equipment & Supplies
...paper level goes down) and has a rubber pad on top, when the rubber pad gets worn and it no longer 'holds' the bottom sheets that are not supposed to feed.You can get these from brother ...
Question about Minolta Office Equipment & Supplies
...level as that of the paper draw. Power off the machine then stick a screw driver into the hole, there is a spring release for manual release. If this is a small tray then you can disconnect the draw ...
...paper level sensor, just move it up and down a couple of times and the issue will go away. the spring on the sensor may be defective. For further troubleshooting, here's an article in the Lexmark ...
...paper and I took it apart to see if I could fix it like suggested here. When I got it apart a small black spring fell out, about the size of one of the screws. does anyone know where this little ...
958 questions posted
Usually answered in minutes!
2,817 Questions
2,162 Questions
1,869 Questions
1,584 Questions
1,504 Questions