...power onPressing power switch, blue light comes on, the BenQ logo briefly flashes then screen stays black Power leak causing overload on the O/L sensor. Probably a faulty capacitor on the power ...
...power switch, blue light comes on, the BenQ logo briefly flashes then screen stays black Check to see if the video cable is connected at both ends securely. Also, if possible, try another
...light on the pwr button and I get no picture. the vga modul can't tobe start power "on",power regulator/switching normal condition. some of the semiconductors on board of the VGA modul ( transistor ) ...
No blue light when on switch pushed in.AC line and cable fine OK,signal from the computer OK. Someone would have to open the unit and see if fuse bad or even puffed up caps in the power supply for it
Question about BenQ FP Computers & Internet
...light is always green (never orange). The display doesn't work either connected to PC with with D-sub or DVI-D. Is hw damaged? Go to CMOS setting on your computer motherboard and check energy saving ...
power light went green then for a half second displayed the blue benq screen and then shut off, green light out as well. Turn it on same thing. I disconnected it from the computer and tried to turn it
Question about BenQ FP Computers & Internet
...power light green. I can only see the screen again after turning it off and on, but that's only for another 1/4 second. What's up? Monitor gives several colors(blue,red,yellow,white) and goes blank ...
light stays blue to indicate video present. Suspect video input controller pcb rather than video panel electronics. Lcd does the same thing each time. What do you think. Resolder the power transistors
...power light is on. any comments/advice please? When you first switch on Does it show Benq?If not the inverter circuit has failed.If you are technically able you can try resoldering transistors on ...
light appears as blue, but nothing on the screen. Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, blown fuses, poor solder joints, failed
79 questions posted
Usually answered in minutes!
111 Questions
116 Questions
57 Questions
37 Questions
36 Questions