Hoover HTC243 Top Load Washer "pump pressure hot" Questions

pump to mine to improve the hot water pressure (UK) Switch over the inlet pipes ie hot to cold and cold to hot and try filling the machine when switched to fill with hot water, (machine will fill will

...pump to think there is too much pressure? You will have to be specific about what problem the pump is having. It seems to pump ok for everything else. Could the hot solenoid be shorting and sending ...

or so yes it cant cause this problem and no your pressure switch will reset its self when the machine is empty of water so perhaps your machine it blocked up traps or filters on the pump / waste end..

...pressure especially on hot, or you will find the hot water trickles into the machine when damanding hot water. I use a seperate pump for the hot, the pump is connected to the hot valve supply and ...

...pressure valve for cold or 1. There is a poor connection at terminals bilge pumps - seal the clamps, clean the terminals. 2. A malfunction in the bilge pump - clean the filter pump washing machine ...

...pressure washer tripping it's GFCI cord every 1-3 minutes after the burner turns on? My landa hot water power washer has a GFCI plug that trips every 1-4 minutes when both the pump and burner are on ...

...pressure switch, drain pump, and Central Control Unit (CCU). Check for drain pump failure and clean it of any debris. Check the inlet valve and pressure switch for proper shut off and operation. ...

...pump and see if anything is in it if the lid switch proves to be ok I have a service manual and videos here How it works most likely its your pressure switch. if you have a multimeter use it to check ...

pump, pressure switch, water inlet value, and Central Control Unit (CCU). 4. Check/clean drain pump filter of foreign objects. 5. Check for drain pump failure. 6. Check the inlet valve for proper shut

pump that could cause this? Thanks. The lid switch has a green ground wire and 2 hot wires. Jump them 2 hot wires and see if she pumps out. More here bypass it here for testing purposes. How it works: