...starts without the button being pressed. How can I get it back to normal where I can press the start when I want it to start? Thank you for the help! I really hope the problem is the start button is ...
...starts without pressing the start switch, then the push to start switch contacts are stuck in the closed position. Sometimes you can press the button on-off-on-off quickly to unjam the contacts, ...
Question about Whirlpool Dryers
...without unplugging the unit.... Try rotating by hand a little. If it starts after that it could be a bad armature and the motor is shot. If it is very difficult to rotate check for something in the ...
...starts by itself if its between a dry cycle. Can you give me some help and, a ruff amount of the cost to repair if its a starter buttom. thanks If that is the newer style start button with 4 wires it ...
...without pressing the button or if the LEDs do not light up when the button is pressed, that button must be stuck or not making any contact when pressed. Replace the control board if the stuck button ...
starts beeping and flashing this code and finally cuts off and all the lights start blinking randomly. Not to long ago the light bulb inside burnt out, but I can't imagine that this is contributing to
...pressing the P button plus Enter) nothing happens. The dryer does work, it's just stuck on one setting. Hello, Welcome to FixYa. By stating "the dryer does work" indicates it is likely an issue with ...
...button pressed down. I found the thermal fuse blown, so I replaced it. This got the dryer to run again but not without the start switch depressed. I replaced the start switch. Same problem. The ...
...button should be pressed to start without normally clicking and needs to be pressed to restart each time you open the door then the start relay could be faulty, sound complicated but not the same ...
453 questions posted
Usually answered in minutes!
62 Questions
45 Questions
31 Questions
35 Questions
36 Questions
