washer code is HR and chimes, what is the problem Error code "Hr" according with the manual is a heater relay failure. Check it diryt or go to bad and need replace it.
hr code Error code "Hr" according with the manual is a heater relay failure. Check it diryt or go to bad and need replace it.
Error Code Hr Machine was in final 1 minute before being finished and the Code Hr came up. This code refers to the built in heating unit. Which has never been used. When I called Maytag they could not
hr error code it just stops with hr flashing Press "end of cycle" to get machine to normal. Then plug off the wall. Check your exit hose spigot, it may be clogged. This is if your filter is all clean.
trouble shooting code HR Possible there is error on the panel , remove power for few minutes and then replug the connection to restart. If the fault appears it can be related to problems in the output
...error code was nd. All we get now is a loud hum but nothing else works. I have read some trouble shooting info which might suggest that the problem might be a frozen pump pulley or the motor is gone. ...
...did it take you to perform that fix that you described? Removing the clutch, lubing, etc. About 2 hr's with a couple coffee breaks and not reseating the clutch pulley properly on the first couple
Hr is water temp control error its likely to be the thermistor or the wires to it. think its in the centre of the heater element on your machine if not it will be near it at the bottom edge of the tub
...hr should reset its computer dam computers I got the same error some day. It was written FP on the little screen and a red led was lit, i simply plugged out the plug for 10 seconds then plugged back ...
...stops washer from working,deal with it or buy a new,Preferably not a kenmore or sears,sears is going under,here is the manual that says nothing about hr error,it will cost 1000's to repair,{it is
167 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions