Question about Kyocera Office Equipment & Supplies
...PWB (YC7) Motor control PWB (YC3) and Engine PWB (YC9) 4. If the wiring is disconnected, shorted or grounded, replace the wiring. 5. Replace the Developer motor MCY. Motor control PWB Replace the ...
Question about Sharp Office Equipment & Supplies
...motor Sorter control PWB defective Check and remedy Check guide bar motor operation with SIM3-10. F1 04 Content Sorter indexer lower limit detected Detail Indexer has exceeded lower limit. Cause ...
...Motor (M1) Mechanical Control Board (PWB-M)DC Power Supply (PU1)Step ActionWIRING DIAGRAMControl SignalLocation (ElectricalComponent)1Check the M1 connector for proper connectionand correct as ...
Question about Kyocera Office Equipment & Supplies
motor) to check for drive problems, 2) Reseat YC27 @ engine PWB and motor connector, 3) Run sim U030. Check YC27-A10 @ engine PWB for a low output. If yes, repl fixing motor, 4) If no, repl engine PWB
Question about Sharp Office Equipment & Supplies
...PWB and the main motor. Control circuit failure L4 01 Check and remedy Check the main motor operation with SIM 25-1. Check the harness and the connector between the MCU PWB and the main motor. 10 ...
Question about Kyocera Mita Office Equipment & Supplies
...Motor (M12) Control Board (PWB-MC) Step Action WIRING DIAGRAM Control Signal Location (Electrical Component) 1 Check the connector of motor for proper connection and correct as necessary. ? ? 2 Check ...
Question about Kyocera Mita Office Equipment & Supplies
...drive system. Replace the cyan toner container. 2. Defective toner motor 2. Replace the toner motor 2. 3. Defective engine controller PWB (A0004). Replace the engine controller PWB
...motor and engine PWB (YC11), or improper connector insertion. solution Reinsert the connector. Also check for continuity within the connector harness. If none,remedy or replace the harness. cause ...
...improper connection Slave unit PWB ? ICU PWB harness trouble Connector pin breakage of the motor PWB of the slave unit PWB Slave unit ROM trouble. no ROM, ROM reverse insertion, ROM pin ...
Motor J210-1 to MCU PWB J407-B1, and if there are no problems, change the MCU PWB. (PL5.4). Check for broken wires or bad connections from Drum Motor J210-1 to MCU PWB J407-Bq Execute DC330 [004-003].
6 questions posted
Usually answered in minutes!
180 Questions
128 Questions
77 Questions
66 Questions
63 Questions