...Faulty door Switch or CCU board or door not closed during run cycle. Starting Diagnostic Test and bypassing the Service History Mode: Execute this procedure with an empty drum. All of the steps below ...
...faulty. You can check this by pushing the door firmly in or (unplug the machine first) removing the front of the door seal and putting your hand around the corner where the door latch goes into. The ...
Question about Whirlpool Washing Machines
...do I jump and where are they according to what I'm looking at it has six wires brown black orange blue whte an gree That unit isn’t designed to be able to bypass door lock. If it’s faulty, replace ...
...bypass door lock on ge gtup270em1ww washer there is only the possibility to leave the machine off for at least 1/2 an hour and try again, if that does not work then the door lock is faulty and you ...
...faulty and latch needs to be replaced. You could do a bypass on the latch to check but i suggest you get a technician to check for you.(not good if you accidently bridge the live to neutral.If same ...
...door and bypass switch to watch the cycle it appears to agitate but I can hold the agitator and move it freely. I can place it in another cycle and it will work in that cycle but it will stay in that ...
...faulty. There would be switch which confirm the Door is closed. If the switch is fault the the lid lock will not get activated and the the machine wont run. Try to find the switch and replace it. If ...
Question about Whirlpool duet Washing Machines
faulty solenoid under the drum that activates the reverse pawl get a technician to inspect and repair. Possible that the drum release lock is not working or is jammed and hence the drive does not work
...faulty PCB. pcb is not really a DIY job as some boards require proramming on certain versions. Regards Advisor Hi, Ive moved into a new flat, and I have a zanussi jet stream 1400 turbo dry front ...
faulty door switch you will need to replace hope this helped :) YOUR LID SWITCH IS BAD,REMOVE THE 2 HEAD SCREWS,ONE ON EACH SIDE,YOU MIGHT HAVE TO POP THE PLASTIC END CAPS OFF AS THE SCREWS ARE BEHIND
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions