...5d error message Check the following to address this issue-- 1. Clogged drain line or water pump Check to see if there's something stuck inside the pump or the drain hose connected to the pump (pump ...
Question about Whirlpool duet Washing Machines
...5d etc. Will run fine for several loads then back to not finishing. Have unplugged it plugged it back in. Doesn't seem to solve anything. Water line screens are clean drain hose is at proper height. ...
...5d mean? "F21" (AKA SD) is a Long (SLOW) Drain error (LD). If the drain time exceeds 8 minutes this error code will be displayed. In addition, a "SUDS" error may also be displayed. This may be an ...
Question about Whirlpool duet Washing Machines
...5d code but I just fixed my washer thanks to the above posts! It was a clogged drain plug. I found 2 socks, a couple bucks in change, a tie pin and a gold braclet, a marker and a crayon. Jeeze!! ...
...5D AND F21 ON THE WHIRLPOOL DUET FRONT LOAD Unplug the washer while servicing inside the unit. Remove the lower kick panel under the door by removing the three 7mm screws under the bottom edge of the ...
5d it does it when its draining before rinse cycle. "F21" (AKA SD) is a Long (SLOW) Drain error (LD). If the drain time exceeds 8 minutes this error code will be displayed. In addition, a "SUDS" error
...5D code on the display of my Whirlpool Duet Sport washer...what do they mean? "F21" (AKA SD) is a Long (SLOW) Drain error (LD). If the drain time exceeds 8 minutes this error code will be displayed. ...
Question about Whirlpool duet Washing Machines
...5d, etc. Will run fine for several loads, then back to not finishing. Have unplugged it, plugged it back in. Doesn't seem to solve anything. Water line screens are clean, drain hose is at proper ...
...stuck in this mode. What do we do? Hi Error code SD/5d means LONG DRAIN. This error appears when the drain time exceeds 8 minutes and the water valves turn off. After 4 minutes the "Sd" error will be ...
Question about Amana Washing Machines
...stuck in the doorway. The lock mechanism may have failed. It could also be that the lock position sensor didn't communicate properly with the washer control board. Note: if the error was 5d, that ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions