Question about Whirlpool duet Washing Machines
...wobbly and the machine was loud and moved across the floor when the spin cycle was on Hi, When my washer did that, I found that the shocks that hold the tub were bad... Check out this tip I wrote ...
washing machine Washing machine tub is wobbling in spin cycle. its supposed to its on shocks and springs so it stayes balanced that way
...and I can leave the water on for months before it happens again. Now if I can only get the spin cycle to work properly. The drom seems to be loose causing excesive wobble resulting in error code
Question about Whirlpool duet Washing Machines
...spin cycle with full load. Ran diagnostics all ok. Cleared drain filter ok. Checked play on drum for bad drum bearing, seems tight to me without play. Pulled rear cover and belt dust everywhere. ...
Question about Whirlpool duet Washing Machines
Whirlpool Duet Washer: WFW8500SR00, SER: HLT 435 78815. Type:832 When checking on my wash I found all the lights on, machine had stopped, laundry had not been spun out. My question, did the wash ...
Question about Whirlpool duet Washing Machines
spin cycle. I did not notice that it was on high spin when I started. I stopped the machine and noticed water leaking from the bottom. The throw soaked the water. I tried washing again today and a lot
Question about Whirlpool duet Washing Machines
...spin cycle. What is causing this?All shocks springs are intact. The pulley is also wobbling with the tub. The pulley is not loose. Everything works fine except for the wobbling tub. Please advise on ...
...spin cycle. It will than stop and display a code "F" ? any help would be awesome if the drum seems to be wobbling or seems out of round,check around the door boot and see if there are any ...
...cycle makes a lot of noise I changed the shock absorbers but it didn't make a difference. It also vibrates See if the tub will spin freely by hand. Spin it both ways. It should coast silently ...
...spin cycle. You might take a look at the pulley. The hole in the pulley should be round with two flat sides. Ours was completely chewed up. This caused the pulley to wobble. We also replaced the belt ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions