...piece of the detergent tray. You must be getting a "DDO" (Detergent Drawer Open) error message. When you removed the detergent tray for cleaning, you probably also removed the white plastic (front) ...
...plastic recessed piece out, there is one screw visible behind it - unswcrew this. If you cannot pull it out now, you should be able to get it after you remove the screws in step 10 5.Pull out the ...
Question about Frigidaire Washing Machines
...plastic recessed piece out, there is one screw visible behind it - unswcrew this. If you cannot pull it out now, you should be able to get it after you remove the screws in step 10 Pull out the ...
Question about Frigidaire Washing Machines
...piece of plastic over the opening, I noticed that the spray of water which rinses out the soap tray was spraying on the plastic pretty hard and reasonably high. That is because the first set of holes ...
...plastic piece that doesn't have a hose attached (unless yours does, in which case figure it out yourself :) ) and gently pull up until you can see the cabinet coming apart in the back. 8. When you ...
...piece, there is a flat tab that extends up into the plastic housing above it. If you gently pull the cover downward and out the whole plastic cover will come off revealing the one screw that needs to ...
...plastic cylindrical piece 2-3" in diameter with a screw cap, remove the cap and clean the filter. You may want to have some towels handy as the water gushed when I took mine off. Also, be sure to ...
Question about Frigidaire Washing Machines
...drawer,two screws,look inside,,looks like a big plastic elbe take off clamps from top and bottom remove rubber see a little plastic cup its cloged up remove and clean out.put back same way...You just ...
piece of fabric and scraps of paper were caught in the pump. Tip 1: If you don't own box wrenches, a couple of wood paint stir sticks work just as well. Tip 2: You don't need a lot of towels if you're
plastic outer drum is joined in the middle with screws. If it is the whole machine has to be stripped. If not you can gain acces by removing the front panel of the machine. To have an engineer do this
3,279 questions posted
Usually answered in minutes!
1,146 Questions
974 Questions
650 Questions
256 Questions
168 Questions