LG WM2277H Front Load Washer "hall sensor" Questions

hall sensor my LG WM2277H needs a new hall sensor. The repairman says that when replacing the sensor you have to replace the motor too. Does that sound reasonable or not? No. Actually, the Hall sensor

...Hall sensor Replaced stator (2nd hall sensor included then no power whatsoever - replaced main board Still no power - replaced line filter, now there is power, but washer will not spin. Stutters ...

...HAll sensor already) I am getting an LE error code on my LG wm2277hb washer. I have tested the stator and it appears to be good (ohms test between connectors). I have also replaced the Hall sensor as ...

Hall sensor might be intermittent. You can test this from the main board connector down to the connector on the hall sensor by checking continuity. There is an intermediate connector down by the motor

...Hall sensor assembly? I have a quote of $260 plus to fix it. I see the part is available through LGPartstore for $156 and found it on another site for $106, although I'm not sure it's both the hall ...

...hall sensor is attached to the stator(motor). Hall sensor helps to direct the motor to spin. If it fails the drum will not spin. It's a very small part (about 3 inches long), with a very big job. The ...

...Hall sensor, clipped onto the motor, can go bad, and is rather easy to replace. (the whole motor is easy to replace, for that matter) LE codes can also be caused by bulky loads, like quilts, sleeping ...

...hall sensor on you motor is faulty or your motor is faulty. your machine will have a direct drive motor which is located at the back of machine. the hall sensor is attached to the motor. 80% of the ...

...HALL SENSOR ON LG TROMM Unplug machine. Remove back panel (4 phillips head screws). Remove large bolt in center of motor. Pull motor rotor off shaft. Remove phillips head screw(s) holding wire ...

...hall sensor I saw your post about replacing the hall sensor. How do you open the top cover of the washer? I've tried unscrewing several screws and wiggling the top around but it won't budge. How did ...