...Drum Motor rotation. Refer to BSD: CH9.1 CH9.1 Procedure Remove the Drum ASSY (Y/M/C/K), execute DC330 [004-003]. Does the Drum Motor rotate? Yes No Between Drum Motor J210-4 (+) GND (-) Is the ...
...machine works after turn off during some seconds. Other time I had to enter on Component Control (DC330), enter "9-215" and got change Low value into High value. But this time I got "9-342" error,
...motor failure. You'll need to check the drum cartridges, remove the cartridges to check. Now enter DC330 [004-003] and press Start. The Drum Motor will now energize and the drive rotates. If it
Question about Xerox Office Equipment & Supplies
...? Remove all Drum Cartridges. ? Perform REP 1.6. Procedure The machine is a DC3535. Y N Enter dC330 [004-003] and press Start. The Drum Motor energizes and the drives rotate. Y N Go to Figure 1 ...
Question about Xerox Office Equipment & Supplies
...after I power down.Please help. 1. Switch off the machine, then switch on the machine. 2. Enter dC330 code 10-100 to heat the fuser to 180 degrees. Enter codes 10-200 (centre thermistor) and ...
Question about Xerox Office Equipment & Supplies
...mark and reposition it properly, if the problem continues, replace the IBT belt ( PL 7.3). Enter dC330 [042-200 Transfer Belt Home Sensor]. Rotate the belt manually for 1 turn. The display
76 questions posted
Usually answered in minutes!
436 Questions
284 Questions
262 Questions
152 Questions
147 Questions