...motor control board, the machine control board senses the motor is not turning when requested to run 1.Run motor control board diagnostic test. 2.Check motor control board for damaged components. ...
Question about Maytag Neptune Washing Machines
...motor control test in service document, I never get any output on the motor output leads to drive the motor. Switching power supply just off the incoming line voltage connector on the motor control ...
Question about Maytag Neptune Washing Machines
...motor control board and the machine control board. Check the motor and motor control system by removing the JP4 connector on the motor control board. Set the timer dial into the delay cycle and then ...
Question about Maytag Neptune Washing Machines
...motor control test" as specified in the service manual: * Disconnect the power * Open washer and disconnect the JP4 Connector from the Motor Control Board * Reconnect Power * Go into Service Mode ...
Question about Maytag Neptune Washing Machines
in the console.This could be a wiring problem between the motor control board in the right hand base area and the main control board up top.Itmost likely is a failed motor control board or drive motor
Motor, Control Board or issues in communication of the Control Board to the Motor Controller/Motor via the wiring harness. Here are a couple of links to support troubleshooting efforts; Service Manual
Question about Maytag Neptune Washing Machines
...Motor Control, motor and Main Control board, but still won't work Dear washer experts: When I saw the fuse blown in the motor control, I purchased the replacement kit that replaces the old motor ...
...motor control board for the older Neptunes. If the motor is not running at all, check that the main control board is sending power to the motor control board. If it is you need the motor/ motor ...
Question about Maytag Neptune Washing Machines
...motor control board kits. Maytag upgraded the washer motors about 5 years ago, if yours is older it's probably got the older style motor. If that's the case you need to verify that the motor control ...
...control board located on the bottom of unit called a motor controller ... it is possible the motor controller has failed.. prior to looking at it though check the main control board for failure such ...
230 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
151 Questions