...door switch, which when bad may not allow agitation or spin. Bare in mind the lid switch assembly can fail either mechanically or electrically. Check the clutch, brake assembly and transmission, one ...
Question about Maytag Neptune Washing Machines
...door lock light still come on, ???place in a spin cycle to check, if need be( it will take a min or so to light), if hte light never comes on i would remove three phillips screws from across teh top ...
...Washing Machine Door Switch and Lock Assembly... DIY WASHING MACHINE FIX Replace or bypass lid switch Washing Machine Lid Switch Bypass Repair Fixing Broken Kenmore Whirlpool Lid Switch for ...
...bypass lid lock PART NUMBER: W10238287 First off, its not a good idea to by pass a door lock assemble. This lid lock sends a signal to the control board and lets the board know the lid is down and ...
...Door lock solenoid 60 ohm and 126 ohm? Duet job aid says 60 ohms on contact point 3 to 2 and 3 to 1 that is not possible because the two windings double the resistance the way its made. My door will ...
...bypass the switch. The motor on those runs the motor which spins the tub and pumps the water out, the lid switch is there to interrupt the motor if lid is opened. Now some of these models have a door ...
Question about Amana Washing Machines
...bypass the lid lock switch? short out the two lives The lid lock switch will appear to be malfunctioning if the WATER to the washer is turned OFF, or if there's not enough water pressure. This is ...
Question about Kenmore Washing Machines
...door lock, but still not entering spin cycle! Is there anything else that could be causing this? There are several possibilities. The belt between the motor and the tub could have broken or slipped ...
...bypass LID LOCK LIGHT STAYS ON NO START: Usually either the lid lock mechanism, the lid lock actuator or the board is the culprit even a disconnected capacitor. MACHINES SAIDS SENSING When the START ...
door lock/switch assembly, or in worst cases a faulty control board. Unplug the machine or disconnect power. Open the washer door then look for the retaining hoop securing the door seal around the lip
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions