Maytag Neptune MAH5500B Front Load Washer "water pressure switch replacement" Questions

...pressure switch not water inlet valve such as yours. Check to make sure your pressure switch is OK by watching the fill point transitions as I mention in the post. If you machine is a series 12 or ...

pressure switch controls the water level in the washer. Remove this tube from the pressure switch and blow back into the machine. There could be a blockage in the tube. To check if the pressure switch

pressure switch Check inlet water valves cold & hot one may be sticking open & can't shut off. The timer may not be shuting off valve , voltage needs to be removed for valve to close. Pressure

...water flow stops correct? You can verify the pressure switch operation by performing and observing the pressure switch transitions on page of 16 of the Service Manual. You should do this to confirm ...

...water valve or intermittent pressure switch. I?m sure you will watch this machine closely. I suspect the pressure switch and would consider replacing after this issue then the water inlet valve just ...

water level in the tub increases, the pressure on the air in the tube increases. When the pressure reaches a certain level, it activates the switch, shuts off the water, and signals the timer to begin

...water bills!) Is there a permanent fix or a recall? maytag has had multiple problems with the neptune series (atlantis included) units. Test the pressure switch for function and continuity, and also ...

water level in the tub increases, the pressure on the air in the tube increases. When the pressure reaches a certain level, it activates the switch, shuts off the water, and signals the timer to begin

...pressure switch stops the water and allows it to start the next cycle. It's a switch either in the control panel or at the top of the tub with a small tube connected to it which goes down between the ...