...clothes are wet after spinning When the clothes are wet at the end of a cycle, check these: Motor coupler To test the motor coupler, re-start the washer in its spin cycle. Let the machine run for a ...
...clothes dripping wet. Spin cycle fails on each type of wash cycle. "Max Extract" also fails to operate. This solution is 100% correct, change the : wax motor &control board.I'll be happy to guide you ...
...are quite wet if the clothes are soaking wet, the tub isn't spinning. Have you stood at the machine and listened for the spin? solution may be as simple as a broken interlock switch. Let me
Question about Maytag Neptune Washing Machines
Cloths still very wet after final spin cycle Spin cycle does not get enough water out of the cloths in the wash load Use spin ccyle again for proper operation and to help remove water.
Question about Maytag Neptune Washing Machines
...do final spin cycle leaving clothes soaking wet. Your drain pump has something lodged in it. Remove drain motor, open it up and inspect for obstruction. remove it then reassemble.retrywashing
Question about Maytag Neptune Washing Machines
...Clothes are still very wet when cycle is over. Looks like you have a clugged up pump and needs to be cleaned out, remember this would be my first check. If the pump is not dirty then chances are it ...
clothes wet My clothes are still very wet at the end of the cycle. It spins ok If it is spinning okay and the clothes are still wet, then I would look at the water inlet valve. Check to make sure that
Question about Maytag Neptune Washing Machines
...wet clothes after the final Spin Cycle? I would place the machine in Service Mode and run it thru a Quick Spin Test (with a wet load) and record the fastest RPM speed the wash basket will spin up to. ...
Question about Maytag Neptune Washing Machines
...clothes still dripping wet after full cycle rich, thanks for your help with my Maytag Neptune TL. I tried your suggestions and the Quick Spin test did reach 850 rpm with a wet load inside, however it ...
...clothes, it won't finish the spn cycle it sounds like there is either an obstruction in the pump, or the load is getting off balance during the spin cycle. two things to try, fill the washer with no ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions