Maytag Neptune FAV6800AW Top Load Washer "cold water problems" Questions

...cold water first, then hot water for the rinse. Any ideas as to what could be the problem. It sounds like you have the hot and cold water lines to the washer reversed. Try turning off the tap for the ...

...cold water during the My Neptune does not fill with cold water during the rinse cycle. It fills with only hot water & the clothes are steaming hot when removed. I was told by my repairman it is ...

...cold water pressure. if you set it to cold/cold, and the water coming in doesn't have much pressure, the screen on the cold water valve could be plugged. turn the water off to the washer, remove the ...

cold water valve the mixing valve is quite an easy repair, but I would have to say with all honesty, it probably time for a new machine the hub seal is a tub replacment call 2 hrs of labor if hes good

cold water will not shut off at end of spin cycle washer finishes the spin cycle but the cold water is still running and the tub fills up. can turn off and select the spin only cycle and the water ...

...Cold water inlet valve we are talking about? We do all wash loads with cold water Wash/Rinse selection on our FAV6800A. You could do this as a temp fix turn off both water supply source valves to the ...

...Cold water only? I would do a Quick Wash cycle just to test with an empty wash basket. Regardless of the above test and assuming you have good water pressure for both Hot and Cold supplies to the ...

...cold water; only hot even when all settings are set to cold, the water is very hot. Yes, the plumbing is correctly set up. Make sure the cold water is turned on ,otherwise a plugged screen in the ...

cold water lines connect, that is the part. To this device are four electrical connectors (pull push type) and a hose inside the washer. It could be that device is the problem. For some folks that see