Question about Maytag Neptune Washing Machines
...machine in a spin only cycle nothing happens and the timer counts down also. I did the "motor control test" as specified in the service manual: * Disconnect the power * Open washer and ...
...HERE IS THE OUTLINE FOR THE CODE LR Lr Locked Monitor Rotor Based in signal information from motor control board, the machine control board senses the motor is not turning when requested to run
Question about Maytag Neptune Washing Machines
how do I unlock the control buton on my maytag front load washer model MFW9700SQ0. The Control Lock is actually a safety feature that enables the consumer to lock the control panel to prevent small ...
Machine won't agitate the neptune unit has a control board located on the bottom of unit called a motor controller ... it is possible the motor controller has failed.. prior to looking at it though ...
...Rotor: The machine has repeatedly tried to turn the motor??. This could be caused by faulty Motor Controller, Motor, Control Board or issues in communication of the Control Board to the Motor ...
Question about Maytag Neptune Washing Machines
I HAVE POWER BUT THE CONTROL PANEL HAS NO POWER PUT IN A LOAD OF CLOTHS AND WASHER WILL NOT TURN ON I HAVE POWER TO THE CORD BUT WASHER HAS NO POWER see this causes and fix it. God bless youCheck ...
unlock the control lock If you have a front loader then Press and hold the "end of cycle" button for 5-10 seconds and it will reset the child safety lock. If the control locked light will not turn off
Question about Maytag Neptune Washing Machines
...again it runs another ten seconds and quits again. it also does this in spin. could this be the control board? The service manual says do this: Runs For Five Seconds Then Shuts OFF: Suspect a ...
...but not move far enough to actuate the 'spin enable' switch. Maytag has upgraded the motor/ motor control board for the older Neptunes. If the motor is not running at all, check that the main ...
Question about Maytag Neptune Washing Machines
Maytag Neptune MLE2000AYW won't spin, motor wont ever move during motor control test in service document, I never get any output on the motor output leads to drive the motor. Switching power supply ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions