Question about Maytag Neptune Washing Machines
...belt issue. The machine is between four and five years old. I bought it new at the Maytag store in Chandler AZ. Hello acelmo3, Thank you for the model number, can you give me the first two digits of ...
Question about Maytag Neptune Washing Machines
belt was going around clutch but clutch didnt move. I stopped the washer and looked around but didn't see nothing else wrong. Tried again and the same thing. Called maytag and they recommended a local
Question about Maytag Neptune Washing Machines
...tumbler rotation direction, any binding? I don?t expect any binding with the motor but you could remove the belt and check for rotational resistance of the motor it should be very light. If you can ...
Question about Whirlpool Washing Machines
...replace+dryer+belt&view=detail&mid=60490DBFF5E697E9AFAC60490DBFF5E697E9AFAC&FORM=VIRE This noise most likely caused,not by the belt,but 1 or more of the moving drum support wheels and or ...
Question about Kenmore Washing Machines
...tumbler will turn but will slow down or stop if I have more than a few clothes in there. Anyway to diagnose? It looks like this model is belt less so I don't know where to start. If I have an ...
Question about Kenmore Washing Machines
...replace the whole back panel (metal) and this shall take care of the alignment of the tumbler; this is a manufacturing problem the metal is not strong enough to support the strain of the tumbler, if ...
Question about Washing Machines
...tumbler slide it forward there will be a hole there rotate the tub to your right and you will find the hole going down to the drain pump can check it there but i don't think you'll find any thing as ...
Question about Maytag Washing Machines
...tumbler. Washer will not drain: Thedrain water pumpis the main part in your washing machine that pumps out the water. If this is defective or has failed in any way, this will be the reason why your ...
belt back on and rock it back and forth to re-seat on the shaft. Without removing the tub, it's a tight work space. We did raise the tube a bit with a lever under the motor to get a bit more clearance
...replace motor belt on front load washer The belt that runs from the motor around the tumbler broke, I bought a kmew one but am having problems getting it to fit. Yes it is the right size belt,I ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions