...issue such as this could be a stuck pressure switch or a water inlet valve not seating properly. If it's a stuck pressure switch and you feel you are overfilling the machine by hitting the PAUSE ...
...issue seems to be a definite stuck pressure switch not water inlet valve such as yours. Check to make sure your pressure switch is OK by watching the fill point transitions as I mention in the post. ...
switch in the lid ??? Hey fireball1711 I'm at work on lunch break I give you a few some info to get ya started. The Left Lid Lock has big time problems with corrosion issues with it?s proximity to the
a broken lid switch issue. The lid switch is inside the washing machine main housing near the door frame. Often you have to raise or open the top or front of the washer to get to the switch. Good luck
Question about Maytag Neptune Washing Machines
...switch. Could be an issue as posted by the other member, could be an issue with the drain pump such as jammed impeller, defective drain pump motor etc. I specialize in FAV6800A/FAV9800A I own the ...
Question about Maytag Neptune Washing Machines
switch sense line was disconnected testing this as an oversuds condition. Hi Thanks for using FixYa. It seems to be an issue with the Timer motor going bad and should be replaced to resolve this issue
...issue but let?s try the Membrane Pad Test to get a start point. See the Service Manual page 15, I have modified the process to make it a bit more understandable at least for me. Make sure the two ...
...issue in one or, all the areas stated. 1. No power to the washer Make sure there's power getting to the washer. Check for a tripped circuit breaker or a blown fuse. Check the wall socket for power. ...
...switch issue here. Its basically a safety issue that states that the lid must be open in order to start the next cycle. open the lid and, press the start button or, pull the timer knob. if the OD ...
...issue. It drains but does not finish the last 8 minutes. The towels are too wet and spin cycle does not complete. Clothes are too wet after spin cycleThis may be a spin problem or a drain problem ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions