...remove the hoses from the back of the machine and use a mirror to peer into the connections of the machine to make sure it doesn't have an accumulation of grit blocking either connection. The ...
programmer is probably still working and trying to initiate pump action. Turn off the water supply, detach the hoses (drop them into a pot to catch residual water), pull the machine out from the wall,
...remove the old valve so you can put them all back in the right place. If the problem goes away when you turn the power off (a far more unlikely result), then you need to look for problems with the ...
...programmer. **unplug the unit from the dryer or wall whichever applies to your situation...safety first** If you are capable remove the rear panel and top panel to ohm out the thermistor to varify if ...
...wall and remove these spades and check the contacts for continuity, you need not remove from machine to do so, no circuit + no heat, replacement item not expensive, thats where to start based on the ...
programmer. **unplug the unit from the dryer or wall whichever applies to your situation...safety first** If you are capable, remove the rear panel and top panel to ohm out the thermistor to verify if
programmer. **unplug the unit from the dryer or wall whichever applies to your situation...safety first** If you are capable, remove the rear panel and top panel to ohm out the thermistor to verify if
wall and look underneath. On the right you will see the drain pump. It looks upside down. Unplug the wiring harness to the pump and remove pump by turning it clockwise while at the same time releasing
...wall and, using the screwdrivers and wrenches, remove the back panel. Using the flashlight, visually check for any broken or loose belts. Replace any broken or loose belts. Although replacing washing ...
1,252 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
680 Questions
658 Questions
476 Questions