Maytag Atlantis MAV6000 Top Load Washer "replace rotor stator" Questions

...replace it with a new one and reverse the proceedure. Be careful when putting it back, the stator has 3 plastic pins for alignment, and when putting the rotor back on watch your fingers as it pulls ...

Replace the assembly by removing the back cover, removing the rotor with one bolt. You have to hold the rotor from turning while loosening the bolt, slide the rotor off of the spline shaft, take off 6

...replace the motor sensor, remove the 4 screws in the back panel to gain access to the motor. Using a 17mm socket, remove the center bolt holding the rotor. Remove the rotor. Using a 10mm socket, ...

...go bad? or the rotor assy? how do I check? Check the sensor attached to the stator assembly. It's called an RPS sensor and it does got bad. Check the reistqnce with an Ohm meter and replace as

is not functioning. replace Hall sensor, if that doesn't fix it make surer the drum turns freely. the rotor never goes bad, and the stator almost never goes bad. replace board if sensor doesn't fix it

Stator rubs against rotor I just replaced the upper and lower bearings, shaft, and tub seal. I have everything back together, but when I move the shaft, the rotor is rubbing against the stator. I have

...replace the RPS, I have repaired a lot of these and have not yet found one that was fixable by cleaning the connections. The Rotor Position Sensor (RPS) is attached to the motor stator (stationary ...

...rotor bowl on motor. Loosen the 4 bolts holding stator & pull stator down to be able to remove the RPS. Mark it's position before removing as it must go back in correct position to work. Replace ...

...an overload situation, if you have changed the Hall sensor and rotor, the only other problem is the stator overheating which will bring on the LE display. Check the stator assembly, replace is

If the hall sensor is out of order, it cannot detect magnetic field and the main board sees it as the rotor is locked then displaying the error code. Replace it if no evidence of defect is found above