...light mean Unplug the power cord for 10 seconds I had this problem and tried all the fixes I found on the internet, clearing paper paths, new toner, unplugging, cold resets, etc. Then I unplugged the ...
ON LIGHT IF FLASHING. THE POWER BUTTON IS FLASHING AND THEN SAYS POWER OFF AND ON. DID THIS AND ITHASNT CHANGED ANYTHING. Could be a Bad NVRAM in the printer, memory went bad if it flashes right away.
Question about HP LaserJet Office Equipment & Supplies
...now the orange light just keeps flashing. i removed the paper and powered down. even unplugged the unit. still flashing Try removing the toner cartridge and re-install it again then recycle the
...power on again, should fix it. Printer says offline and yellow light is flashing on the back of the printer where you plug in the network cable. Changed cable but it makes no difference. Any ...
...light flashing. No errant paper, no problem with toner, no misfeed, no jam. Power-down/power-on sequences have no effect. Does not power up, that is, no motors. Each time lights cycle between green ...
Question about HP LaserJet Office Equipment & Supplies
...light pattern, won't respond When I power up the printer it doesn't go into its initialisation routine - the toner light is off, the attention light in on, and the ready & go lights are flashing. The ...
...HP LaserJet 1022 cold reset procedure To cold reset the printer, perform the following steps: Power off the printer.Power on the printer while depressing both the Go and Cancel buttons. Keep
Question about HP LaserJet Office Equipment & Supplies
...light keeps flashing and I'm unable to print. I'm running OS X 10.8.2 1. Check any paper jams in side. 2. Check cartridge. 3. Remove back cover, clean paper sensors. 4. Replace ...
Question about HP LaserJet Office Equipment & Supplies
...reset the page counter for the next maintenance kit replacement. Does anyone have the instructions Power off the printer.Power on the printer while depressing both the Go and Cancelbuttons. Keep the ...
...that report and in printer properties that toner save is turned off, if still too light you may need a new laser unit as they lose power in time, I would try another toner cart. before buying a
957 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
663 Questions
593 Questions
492 Questions
